RM00034 Stator Ignition Source Coil Kawasaki KVF 750 Brute Force 08-09 KX 125 250 92-97 Yamaha YZ 125 92-95
Technische Daten:
Big Coil : Between each leg = 323 ohms+/-20%
Small Coil : Between each leg = 20 ohms+/-20%
Kawasaki 750 KVF 750 Brute Force HD 4x4i 08-09
Kawasaki KX 125 92-97
Kawasaki KX 250 92-93
Kawasaki KX 250 95
Yamaha YZ 125 92-95
KawasakiI 1992-1997 KX125, 1992-97 KX250
Take the ignition cover off.
Take note of the wire colors of the original stator wires and disconnect them from the wiring loom.
Remove the flywheel using a proper puller tool.
Remove the baseplate with the original stator.
Remove the screws that secure the ignition coils and take the coils off.
Cut the original wires close to the original coils. Take agood look at how the wires are connected to the coil.
Connections:
Large coil connects to the Black/Red and the Red wire.
Small coil connects over to the large coils Red wire and the other side to the White wire.
Connect the wires on the same side of the coils as the original setup.
Connect the old wires up to the new coils. Put the wires in exactly the same place as on the original. Make sure you have good connections here
Mount the coils onto the baseplate, fit the screws using locking compound on the threads and TIGHTEN THE SCREWS SECURELY!
Refit the stator baseplate. Ensure the wires CANNOT TOUCH THE FLYWHEEL! (especially on the inside of.
Yamaha YZ125 1992
Take the ignition cover off.
Take note of the wire colors of the original stator wires and disconnect them from the wiring loom.
Remove the flywheel using a proper puller tool.
Remove the baseplate with the original stator.
Remove the screws that secure the ignition coils and take the coils off.
Cut the original wires close to the original coils. Take a good look at how the wires are connected to the coil.
CONNECTIONS:
Large coil connects to the Brown wire, connect the other side up to the Red wire.
Small coil connects to the Black wire (=ground), connect the other side up to the White wire.
Connect the old wires up to the new coils. Put the wires in exactly the same place as on the original.
Make sure you have good connections here.
Mount the coils onto the baseplate, fit the screws using locking compound on the threads and TIGHTEN THE SCREWS SECURELY!
Refit the stator baseplate. Ensure the wires CANNOTTOUCH THE FLYWHEEL! (especially on the inside of the flywheel)
Refit the flywheel. Tighten the bolt to specified torque.
Connect the wires to the wiring loom on the bike. Refit the ignition cover.
Connect the wires to the wiring loom on the bike.
Filll the ignition cover
